Technical Workshops

Introduction to Ideation & Computer-Aided Design (CAD)

The workshop teaches the fundamentals of design thinking and the basics of computer-aided design with Fusion 360 and manufacturing methods. Use the link below to access the workshop presentation:

• Presentation coming soon

Figure 1: Fusion 360 Hex Nut model

Introduction to Arduino

The workshop focuses on Arduino hardware, electrical components, building circuits on a breadboard, and understanding Arduino IDE. Use the links below to access the workshop videos and presentations:

• Presentation coming soon

Figure 2: Arduino Hardware

Introduction to Raspberry Pi

The workshop focuses on understanding Raspberry Pi, how to set it up and its various applications. Use the links below to access the workshop videos and presentations:

• Presentation coming soon
  

  Figure 3: Raspberry Pi Set Up

Introduction to Circuitry

The workshop teaches the basics of circuitry, reading schematics, wiring breadboards, and gain rudimentary understanding of electronic components in a circuit. Use the links below to access the workshop videos and presentations:

• Presentation coming soon
  

  Figure 4: Circuit on a Breadboard

Revit

This training focuses on the creation of a household bathroom, and covers architectural and plumbing plans, sanitation, hot, and cold plumbing, and troubleshooting common problems with resources from the manual.

• Presentation coming soon

File:Bathroom In Revit

Figure 5: Bathroom in Revit (Image Credit: Bradley Corp)

Soldering

The training teaches the basics of circuitry basics, soldering, and desoldering. NOTE: Viewing this presentation does not count as completion of soldering training. You must visit Modelshop to have in person soldering training. Use the link below to access the workshop presentation:

• Presentation coming soon

File:Soldering a Circuit Board

Figure 6: Soldering a circuit board