Difference between revisions of "Template:SLDP: Drawings (Robots)"

Revision as of 03:12, 11 September 2014

Drawings

All drawings and sketches should be made using MLCad or Lego Digital Designer.

Create four drawings of the robot: front, top, most detailed side, and a drawing of the gear trains. Sensors, motors, and gears must be included in each drawing. If the robot does not use any gears, make sure to explicitly state that during the presentations.

Each revision of the design must be documented and all changes must be presented during Milestone presentations.

Figure {{{1}}}: Sample isometric image from MLCad (without part numbers)

Revision as of 18:34, 8 September 2014 (view source) Admin (talk \| contribs) (→‎Drawings) ← Older edit		Revision as of 03:12, 11 September 2014 (view source) Admin (talk \| contribs) Newer edit →
Line 6:		Line 6:
	Each revision of the design must be documented and all changes must be presented during Milestone presentations.		Each revision of the design must be documented and all changes must be presented during Milestone presentations.

	[[Image:Modular6.gif\|frame\|center\|Figure 2: Sample isometric image from MLCad (without part numbers)]]		[[Image:Modular6.gif\|frame\|center\|Figure {{{1}}}: Sample isometric image from MLCad (without part numbers)]]