Difference between revisions of "Template:SLDP: Drawings (Robots)"

Revision as of 18:34, 8 September 2014

Drawings

All drawings and sketches should be made using MLCad or Lego Digital Designer.

Create four drawings of the robot: front, top, most detailed side, and a drawing of the gear trains. Sensors, motors, and gears must be included in each drawing. If the robot does not use any gears, make sure to explicitly state that during the presentations.

Each revision of the design must be documented and all changes must be presented during Milestone presentations.

Figure 2: Sample isometric image from MLCad (without part numbers)

@@ Line 2: / Line 2: @@
 All drawings and sketches should be made using '''MLCad''' or '''Lego Digital Designer'''.
-Create four drawings of your robot: front, top, most detailed side, and a drawing of your gear trains. Sensors, motors, and gears must be included in each drawing. '''If your robot does not use any gears, make sure to explicitly state that during your presentations.'''
+Create four drawings of the robot: front, top, most detailed side, and a drawing of the gear trains. Sensors, motors, and gears must be included in each drawing. '''If the robot does not use any gears, make sure to explicitly state that during the presentations.'''
-Each revision of your design must be documented and all changes must be presented during milestone presentations.
+Each revision of the design must be documented and all changes must be presented during Milestone presentations.
 [[Image:Modular6.gif|frame|center|Figure 2: Sample isometric image from MLCad (without part numbers)]]