|
Tags: Blanking Manual revert |
| (2 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| # Open the file above
| |
| # In Hover the mouse over the design and left-click once a blue box surrounds the design. This will highlight every element in the design (Figure 1).
| |
| #: [[Image: ___|400px|thumb|center| Figure 1: Highlighting Elements in the Architectural Plan]]
| |
| # Select the pin icon under the '''Modify''' tab (Figure 4). This prevents the linked file from being moved.
| |
| #: [[Image:___|400px|thumb|center| Figure 2: Pin Icon]]
| |
| # Open the L1 - Plumbing floor plan by going to the project browser and expanding the '''Plumbing''' dropdown (Figure 3).
| |
| #: [[Image:___|400px|thumb|center| Figure 3: Plumbing Plan in Project Browser]]
| |
| # Go to the '''View''' tab, select '''Callout.''' Click and drag over a large area of space containing the bathroom on the first floor (Figure 4).
| |
| #: [[Image: ___|400px|thumb|center| Figure 4: Callout of the Bathroom]]
| |
| # Go into the callout view by double-clicking on the generated circle
| |
| # Select '''Plumbing Fixtures''' under '''Systems''' tab. Under the '''Mode''' tab, select '''Load Family.''' Place a sink, toilet, and shower into the bathroom using the file paths provided in Table 1 below.
| |
|
| |
|
| :: {|class="wikitable" style="float: center; margin-top: 0px; margin-left:13px;"
| |
| |+style="caption-side:bottom; white-space:nowrap;"|Table 1. File Paths.
| |
| ! '''Components''' !! '''File Paths'''
| |
| |-
| |
| |Sink || English Imperial → Plumbing → MEP → Fixtures → Sinks → Sink - Work
| |
| |-
| |
| |Toilet || English Imperial → Plumbing → MEP → Fixtures → Water Closets → Water Closet - Flush Tank
| |
| |-
| |
| |Shower || English Imperial → Plumbing → MEP → Fixtures → Shower → Shower Stall - Rectangular
| |
| |}
| |
| <ol start ="8">
| |
| # Make sure the fixtures al aligned to the wall and placed in the correct orientation. Use the spacebar to rotate the fixtures if necessary.
| |
| ## Note: Make sure that the sink is offset 3 ft off the ground in the '''Properties''' sidebar (Figure 5).
| |
| ##: [[Image: ___|400px|thumb|center| Figure 5: Properties Sidebar]]
| |
| <ol start ="9">
| |
| # Three piping systems can be created: a hot water system, a cold water system, and a sanitary system. In this workshop, only the cold water system will be used. To add pipes, click on a fixture and select the '''Create Pipe''' icon (Figure 6). Choose the cold water icon and not the sanitary icon.
| |
| #: [[Image: ___|400px|thumb|center| Figure 6: Create a Pipe Icon]]
| |
| # In the properties section, ensure that the pipe is selected as PVC - DWV and set the diameter to 1/2" (Figure 7).
| |