|
|
| Line 1: |
Line 1: |
| == Design 2: Lighting System ==
| | |
| Build a VI that simulates a lighting system in a house with four rooms. The design must include four lights (LEDs) and at least five switches — one switch per light and one master switch that will turn all of the lights off simultaneously (think of this as a circuit breaker). The program should also interact with real LEDs located on the NI-ELVIS board.
| |
| # The '''''front panel''''' of the program should include five switches and four LEDs.
| |
| # The '''''back panel''''' requires a '''''case structure''''' for the master switch to turn off all the lights.
| |
| # In order to control the LEDs on the NI-ELVIS board, a '''''NI ELVISmx Digital Writer''''' node is required on the back panel.
| |
| ## To access the '''''NI ELVISmx Digital Writer''''' node, click on '''''Measurement I/O''''' on the '''''functions palette''''', open '''''NI ELVISmx''''', and select '''''Digital Writer'''''. (see Figure 19)
| |
| ##: [[Image:lab_labview_56.png|frame|center|Figure 19: NI ELVISmx measurement I/O functions.]]
| |
| ## Once these are placed on the '''''back panel''''', the '''NI ELVISmx Digital Writer''' dialog box will open. Click OK.
| |
| ## The '''''NI ELVISmx Digital Writer''''' is used for writing information to the NI-ELVIS board. For the purposes of this lab, only two pieces of information need to be presented to the '''Digital Writer''' node: '''DO Lines''' and '''Lines to Write'''.
| |
| ##: [[Image:lab_labview_58.png|frame|center|Figure 20: NI ELVISmx Digital Writer.]]
| |
| ### '''DO Lines (Boolean array)''': This determines which DIO rows on the NI-ELVIS board will be activated (in other words, which LEDs will light up).
| |
| ### '''Lines to Write (ring constant)''': This determines which eight DIO rows can work on the NI-ELVIS board.
| |
| #### For the purposes of this lab, DIO lines '''0–7''' will be utilized. To establish this setting, right-click the '''Lines to Write''' row on the '''''NI ELVISmx Digital Writer''''', select ''Create'', followed by ''Constant''. The '''Operate Value''' tool can be used to manipulate this value. By default, it is set to '''0–7'''.
| |
| ## The switches should be wired to a '''''Build Array''''' icon, along with four '''False''' constants. Conceptually, think of a vehicle that only departs when all the seats are filled. In this case, the ''DO Lines'' is a road only allows vehicles with eight passengers to travel to the NI-ELVIS board. So in order for information to flow from the VI to the NI-ELVIS board, '''Build Array''' must provide a vehicle (i.e., an array) with eight passengers or outputs (i.e., the four Boolean switches and four '''False''' constants). '''''Build Array''''' can be found under '''Programming''' on the '''''functions palette''''' by clicking '''Array'''. (see Figure 21)
| |
| ##: [[Image:lab_labview_67.png|frame|center|Figure 21: Array programming functions.]]
| |
| ## Also keep in mind that if the master switch is off, then all of the LEDs connected to the NI-ELVIS board should shut off as well.
| |
| # In order for the LEDs on the NI-ELVIS board to light up, wires must connect the DIO lines (rows 0–23) directly to the LEDs on the NI-ELVIS board (rows 35–42).
| |