Technical Workshops

From EG1004 Lab Manual
Jump to: navigation, search

Introduction to Ideation & Computer-Aided Design (CAD)

The workshop teaches the fundamentals of design thinking and the basics of computer-aided design with Fusion 360 and manufacturing methods. Use the link below to access the workshop presentation:

Figure 1: Fusion 360 Hex Nut model

Introduction to Arduino

The workshop focuses on Arduino hardware, electrical components, building circuits on a breadboard, and understanding Arduino IDE. Use the links below to access the workshop videos and presentations:

Figure 2: Arduino Hardware

Introduction to Raspberry Pi

The workshop focuses on understanding Raspberry Pi, how to set it up and its various applications. Use the links below to access the workshop videos and presentations:

Introduction to Circuitry

The workshop teaches the basics of circuitry, reading schematics, wiring breadboards, and gain rudimentary understanding of electronic components in a circuit. Use the links below to access the workshop videos and presentations:

Revit

This training focuses on the creation of a household bathroom, and covers architectural and plumbing plans, sanitation, hot, and cold plumbing, and troubleshooting common problems with resources from the manual.

Figure 5: Bathroom in Revit (Image Credit: Bradley Corp)

Soldering

The training teaches the basics of circuitry basics, soldering, and desoldering. NOTE: Viewing this presentation does not count as completion of soldering training. You must visit Modelshop to have in person soldering training. Use the link below to access the workshop presentation:

Figure 6: Soldering a Circuit Board