Template: SLDP: Drawings (Robots)

From EG1004 Lab Manual
Revision as of 03:34, 4 October 2018 by Dfrancisco (talk | contribs) (Reverted edits by Dfrancisco (talk) to last revision by Admin)
Jump to: navigation, search

Drawings

All drawings and sketches should be made using Lego Digital Designer.

Create four drawings of the robot: front, top, most detailed side, and a drawing of the gear trains. Sensors, motors, and gears must be included in each drawing. If the robot does not use any gears, make sure to explicitly state that during the presentations.

Each revision of the design must be documented and all changes must be presented during Milestone presentations.

Figure {{{1}}}: Sample isometric image from Lego Digital Designer (without part numbers)